Putting in RAMBo Driver | MatterHackers

MatterControl now embrace a driver for RAMBo boards straight within the software program. In case your machine makes use of a RAMBo board and has a profile constructed into MatterControl, the proper driver will likely be put in as a part of the printer setup.

If are utilizing Home windows and your 3D printer makes use of a RAMBo board, you will want to put in the RAMBo Home windows driver earlier than going by the setup course of.  As soon as the driving force is put in you may undergo the conventional MatterControl printer setup to get your printer up and working.

Putting in the RAMBO driver

Listed below are the steps you might want to do to get the RAMBo drivers put in.

1. If you’re working on Home windows 8 you will want to observe instructions beneath earlier than you attempt to set up the driving force
2. Run the MatterControl Setup and undergo the set up wizard to put in it
3. Run the Home windows Machine Supervisor
   1. You could find the Machine Manger by looking for it within the Management Panel
4. Plug in your printer
5. In Machine Supervisor it is best to discover a part “Different Gadgets” and an merchandise withn it “RAMBo”
6. Proper click on on “RAMBo” and choose “Replace Driver Software program” from the menu that seems
7. Click on on “Browse my pc for driver software program”
8. Click on the “Browse” button
9. Navigate to “C:Program Information (x86)MatterControlStaticDataDrivers” and Click on OK
10. Click on “Subsequent”
11. Your RAMBo driver ought to now be put in and you may run the printer setup wizard in MatterControl to complete seting up your printer

Home windows 8 Customers
If you're working Home windows 8, you will must restart your pc in Disable Driver Signature Enforcement 
mode earlier than you may set up the driving force. These steps are additionally required for the set up of the v.5.5 driver. 
1.    Find the choices on the precise facet of the display > choose Settings 

Settings Icon inside Choices

2.    Choose the Change PC settings hyperlink

3.    After opening the Management Panel, choose Replace & Restoration > choose Restoration

4.    A bit referred to as Superior startup will seem > choose Restart now 

Superior startup

5.    After the pc restarts, choose Troubleshoot > Superior choices > Startup Settings > Restart

6.    When the pc begins, choose F7 besides with the driving force signature verify disabled 

At this level, you may transfer on to putting in the driving force within the information above.